Imagine Versio, Руководство по установке

Страница: 42 / 78

40 Chapter 2 | System Installation
Ve r s i o H a r d w a r e I n s ta l l a t i o n M a n u a l
© 2015 Imagine Communications
Proprietary and Confidential
Chassis Rack Installation
This section provides steps for installing the chassis into the rack unit you are using.
Rack Location
Decide on a suitable location for the rack unit that will hold your chassis. It
should be situated in a clean, dust-free area that is well ventilated. Avoid areas
where heat, electrical noise and electromagnetic fields are generated. The
system needs to be placed near a grounded power outlet. Be sure to read the
Rack and Server Precautions in the next section.
Prepare for Setup
The box your chassis was shipped in should include two sets of rail assemblies
and the mounting screws needed for installing the system into the rack. Please
read this section in its entirety before you begin the installation procedure
outlined in the sections that follow.
Choosing a Setup Location
• Leave enough clearance in front of the rack to enable you to open the front
door completely (~25 inches).
• Leave approximately 30 inches of clearance in the back of the rack to allow
for sufficient airflow and ease in servicing.
• This product is for installation only in a Restricted Access Location
(dedicated equipment rooms, service closets and the like).
Warnings and
Precautions
Rack Precautions
• Ensure that the leveling jacks on the bottom of the rack are fully extended
to the floor with the full weight of the rack resting on them.
• In single rack installations, stabilizers should be attached to the rack.
• In multiple rack installations, the racks should be coupled together.
• Always make sure that the rack is stable before extending a component
from the rack.
• You should extend only one component at a time. Extending two or more
simultaneously may cause the rack to become unstable.
General System Precautions
• Review the electrical and general safety precautions that came with the
components you are adding to your chassis.
• Determine the placement of each component in the rack before you install
the rails.