Imagine Selenio X50, Инструкция по установке и эксплуатации, Страница: 36 / 136

Chapter 2
Installation
22
Configuring Third-Party SNMP Software Control
SNMP is an industry-standard protocol that allows other manufacturers’ control software to
remotely monitor and control the X50.
Harris provides MIB files that can be downloaded from the website. Two general MIB files
(
leitch.mib and ccsAlarm.mib ) set up the structure to define parameters and alarms. Once
these two MIBs are installed, you will want to install a MIB for each distinct module for
which you wish to set up third-party software control.
You can use any standard MIB browsing software with your X50.
1 Make the required network connections between the X50 unit(s) and your PC with installed
SNMP browser/control software.
The SNMP configuration process for the X50 directs the SNMP agent where to send alarms
(SNMP traps). This file must be modified before it is loaded back to the X50. For information
on configuring SNMP, see page 19.
2 Load the leitch.mib file into your SNMP browser/control software.
This MIB sets up the basic structure for product specific Harris MIBs. It can be found under
the
Private > Enterprise branch, and sets up the leitchProducts and leitchCommon
sub-branches.
The leitchCommon branch is initially empty. The leitchProducts branch contains folders
for different families of Harris devices—for example, LeitchX75 , NEO and X50.
3 Load ccsAlarm.mib into your SNMP browser/control software.
This MIB adds a ccsAlarms sub-branch to the leitchCommon folder. When it is installed,
you will be able to receive traps with proper information as to where the alarms are
triggered from.
4 Load product-specific X50 MIB files into your SNMP browser/control software.
A product-specific MIB provides a clear path to the parameters and alarms on the device.
Harris MIBs can be downloaded from our website.
X50 MIBs will appear in the X50 folder under the leitchProducts folder. See Figure 2-13
on page 23.
5 Configure your MIB browser to connect to the unit by entering the IP address , Port (if you
have changed the Port from its default in the configuration), and other standard
configuration settings.
Your browser should now be able to connect to the SNMP agent running on the X50 unit. If
you wish to receive traps, start up the trap receiver in your MIB browser software.
Note: To verify that your configurations are correct, you can walk MIB2.