Imagine Selenio 6800 HUC6801+D, Инструкция по установке и эксплуатации

Страница: 25 / 62

HUC6801
+
D
Installation and Operation Manual
13
Copyright © 2010, Harris Corporation
3 Rotate the hex switch to the parameter number (1 to 9) or letter (A to F) of the option you
want to set.
4 Toggle the navigation switch to select and set the value of the chosen parameter.
5 Rotate the hex switch to another parameter number/letter in the current bank, and then
repeat step 4 or...
Rotate the hex switch to “0” again to select a different bank, and then repeat steps 3
and 4.
Note: Harris recommends that you use software control options to aid in viewing, setting,
and confirming parameter values.
Enabling On-Screen Display
You can use the On-screen Display (OSD) Monitoring feature to view the current parameter
selections on your output display. When the
On-Screen Display parameter is turned on,
the current parameter selections are displayed on the module’s HD PROG/MON OUT 1 and
HD PROG/MON OUT2 outputs. This feature makes configuring the HUC6801
+
using the
card-edge controls much easier.
To enable On-screen Display (OSD) Monitoring make the following selections:
Recalling
Default
Parameter
Settings
You can use the module’s Factory Recall parameter to return all of the module’s
parameters to factory default settings. In the HUC6801
+
D control parameter list (see
page 27), each factory default setting appears in bold.
To return this module to its default settings, make the following selections:
Reading
Software and
Hardware
Versions
You can see the current software and hardware versions of the HUC6801
+
D by checking
the Hardware Version and Firmware Version read-only parameters located at the end of the
parameter list (see
D Control Parameters on page 27). These parameters
appear in the OSD and on CCS-enabled control panels or CCS software applications such as
Pilot or Navigator.
Setting Description Parameter Navigation
Enable OSD monitoring. Video Setup Output On-Screen Display
[
0 , 2 ]
On
Set OSD transparency value. OSD Transparency
[
0 , 3 ]
0–15
Setting Description Parameter Navigation
Recall factory default settings. Other Setup Other Factory Recall [ 0 , F ] Yes