Imagine Selenio 6800 HUC6801+D, Инструкция по установке и эксплуатации

Страница: 21 / 62

HUC6801
+
D
Installation and Operation Manual
9
Copyright © 2010, Harris Corporation
Local and Remote Jumper Settings
Follow this procedure to set the REM/LOC jumper for either remote or local control:
1 Locate the REM/LOC control jumper (shown in Figure 2-1 on page 8).
2 Place a jumper on pins 1 and 2 to set the module for Remote control, or pins 2 and 3 to set
the module for Local card-edge control ( Figure 2-2 ).
Figure 2-2 REM/LOC Settings for Remote and Local Control
Note: You must configure modules for local or remote operation prior to power-up. To
change the configuration, first remove power from the module, reset the jumper, and then
reapply power. The white triangle near the jumper pins on the module indicates pin 1.
See Table 1-1 on page 3 for more information on local/remote control jumper functionality.
Genlock Termination Jumper Settings
Follow this procedure to set the Genlock Termination jumper J1 :
1 Locate jumper J1 on the module, near the back of the module (see Figure 2-1 on page 8).
2 Place a jumper on pins 1 and 2 to set the module to No Termination, or pins 2 and 3 to
select 75
Ω
Onboard Termination (see Figure 2-3 ).
Figure 2-3 Genlock Termination Settings
1 2 3 1 2 3
Remote control Local control
1 2 3 1 2 3
No Termination 75
Ω
Termination