Imagine Nexio AMP NX3801 HDI Gen6, Руководство по установке оборудования и инструкция пользователя

Страница: 67 / 74

NXAMP3801HDX/HDI
NEXIO AMP Generation 6 Hardware Installation and User Guide
67
175-100423-00
Replacing Media Drive - HDI Only
This section provides information on replacing a media drive. Detailed information is provided in the NEXIO
LOW LEVEL MODULE USER GUIDE . There is usually no need to stop the LLM to replace the media drive. It
is recommended that the system is running throughout the replacement process.
1 Refer to Figure 8-9 to identify the media drive. Drive numbers shown in red.
2 For removal and replacement of a media drive, refer to Hard Drive Removal or Replacement on
page 65.
Figure 8-9 NXAMP3801HDI Front Panel Showing Media Drives
3 Follow the instructions in the NEXIO Low Level Module User Guide .
AMI BIOS Recovery
WARNING : Do not upgrade the BIOS unless your system has a BIOS-related issue. Flashing the
wrong BIOS can cause irreparable damage to your system. If you need to update the BIOS, do
not shut down or reset the system while the BIOS is updating to avoid possible boot failure.
1 Insert the Harris supplied USB stick that contains the new BIOS binary image and power the system
down.
2 Press the main power switch ( Figure 8-1 on page 61) on the front panel of the NXAMP3801HDX/HDI
and press and hold < Ctrl > and < Home > simultaneously on your keyboard until the USB device's LED
indicator comes on. This will take a few seconds or up to one minute.
3 Once the USB device's LED is on, release the < Ctrl > and < Home > keys. The system may generate
beep codes to indicate that the BIOS ROM firmware is being updated. The screen will also display a
message as shown below:
DO NOT INTERRUPT THIS PROCESS
4 When the Boot Sector Recovery Process is complete, the system will reboot automatically.
5 When DOS prompt appear, please type AMI.BAT BIOSname.###.
6 Do not interrupt the process until the flashing is complete.