41
5
Monitoring Your
NXAMP3801HDX/HDI
Status Monitoring
This chapter describes how to monitor the status of the NXAMP3801HDX/HDI.
Remote Monitoring Using IPMI
System administrators needing remote access to monitor the performance of the NXAMP3801HDX/HDI can
enable the IPMI sub-system available on their server. The IPMI is a special network port available on the back
of the NXAMP3810HDX/HDI (see
Back Panel Components
on page 26) which allows access to the server
even in a power off or system failure state. All it requires is that the server be connected to a power source
and the IPMI port connected to a local area network.
By default the IPMI is disabled on the NXAMP3801HDX/HDI servers. It must be enabled through the
computer BIOS.
BIOS Setup
1
Press the
Del
key at bootup to enter the
BIOS Utility
.
2
From the menu bar select
IPMI
and press the
Enter
key.
3
Using the keyboard up or down arrow, select
BMC network configuration
and press the
Enter
key.
Figure 5-1 IPMI
Menu
Содержание Nexio AMP NX3801 HDI Gen6
