Imagine communications Selenio 6800 SFS6803+OP+SFS+, Инструкция по установке и эксплуатации

Страница: 37 / 118

SFS6803
+
and OP
+
SFS
+
Installation and Operation Manual
23
2 On the side of the back module that inserts into the front module, remove the inner
protective cap from the fiber connection (see
Figure 2-6 on page 22).
CAUTION: Microscopic dust or other contaminants can seriously impair or disable a
fiber optic network. Observe strict cleaning procedures. Do not touch the end of
the fiber.
3 Follow the inspection and cleaning procedure that begins on page 24.
4 If it is already installed, remove the front module from the slot.
5 Install the new back module by inserting the bottom lip into the required frame slot, and
then screwing it into place.
Ensure that the EMI gaskets on the right side of the back module remain in place during the
installation. The EMI gaskets fit tightly.
6 Apply the adhesive label to the back module if it is supplied separately.
Front Module Installation
Follow these steps to install the front module:
1 Pull out the finger-release screws on the right and left side of the front panel of the frame,
and then open it.
2 Locate the front module slot that corresponds with the matching back module.
3 Gently remove the outer and inner protective caps from the laser connections. (See
Figure 2-6 on page 22.)
CAUTION: Microscopic dust or other contaminants can seriously impair or disable a
fiber optic network. Observe strict cleaning procedures. Do not touch the end of
the fiber.
4 Follow the fiber cleaning instructions that begin on page 24.
5 Ensure that your front module matches with a corresponding back module of the same
name.
6 Slide the module into the guides in the frame.
7 When the module edge is flush with the guide, close the extractor handle.
The module is properly seated when its edge is flush with the guide edge and the extractor
handle closes.
8 Close the front panel to ensure proper frame ventilation.
To prevent overheating, keep the front panel closed and all back module plate slots covered
during operation.
Removing OP
+
SFS
+
Modules
Note: The removal steps provided here are similar to those outlined in your 6800
+
Frame
Installation and Operation Manual. Refer to that manual for detailed information about
installing and operating the frame and its components.
Front Module
Follow these steps to remove a front module from a frame: