Imagine communications Selenio 6800 HUC6800, Инструкция по установке и эксплуатации

Страница: 74 / 84

60 HUC6800
+
Installation and Operation Manual
Appendix A: Communication and Control Troubleshooting Tips
• A legacy 6800 series product is in the frame.
+
Pilot Lite cannot
communicate with legacy 6800 series products. They will not be
discovered or controlled by
+
Pilot Lite, although they can be
installed in the FR6802
+
frame and work using card edge controls.
The module must be from the 6800
+
product family.
• Check that the back module does not have any bent pins. Follow
this procedure:
a. Unplug the front module first
b. Unscrew and remove the back module.
c. View the 30-pin spring connector at the bottom of the back
module. See Figure A-1 .
Figure A-1. Connector on 6800
+
Back Module
This connector should not have any bent or pressed pins. Even
a slightly depressed or bent pin may cause genlock issues.
d. If there are bent pins, carefully re-position them to their correct
positions.
If this is not possible, a back module can be obtained from the
manufacturer.
+
Pilot Lite Does Not Find All Modules in Frame
If a discovery is started too soon after frame power-up,
+
Pilot Lite will
not find all the installed modules. Refresh
+
Pilot Lite ( File >
Refresh ), and ensure that installed modules are fully powered-up first
before discovery.
30-pin
connector