Imagine communications Selenio 6800 HUC6800, Инструкция по установке и эксплуатации

Страница: 32 / 84

18 HUC6800
+
Installation and Operation Manual
Chapter 2: Installation
4. On the Device tab of the Navigation Properties box, enter the IP
address of the frame that holds the module. (See Figure 2-5 .)
Figure 2-5. Navigation Properties Box
5. In the third field, enter the slot number of the module, and then
close the window.
You can now continue upgrading your device’s firmware, starting with
step 3 on
“Upgrading the Firmware” on page 15 .
Correcting a Failed Upgrading Procedure
Firmware upgrades may fail in the event of network interruptions,
power failures, or if files were sent to the wrong 6800
+
module.
These problems can be corrected by re-installing the firmware while in
Boot Loader mode, as described in the following pages. Before you
perform this procedure, check the appropriate readme file to confirm
which files are needed. Use care to ensure that you upload the correct
files to the intended module.
Caution
If you make changes in the last
field (located above and to the
right of the
Set Default button),
you may lose your connection to
the module. If this happens, you
will need to rediscover the
module.
Do not make changes in
this field
Enter frame IP number here