14
TORQUE MEASUREMENT
Negative (–)
Positive (+)
CR2354 Poles
REPLACING THE BATTERY
When the display starts flashing, the battery needs replacement.
Turn the driver over and loosen the battery cover screw with a
Phillips screwdriver. Remove the battery cover and the old battery.
Replace it only with a lithium ion coin battery (Panasonic CR2354).
Do not use equivalents.
Note the polarity when installing.
Wrap the old battery with adhesive tape to insulate it from other
objects before recycling.
10
BATTERY
BATTERY COVER SCREW
BATTERY COVER
POSITIVE GOES TO THE OUTSIDE
Use Panasonic CR2354 batteries only.
Available from www.imada.com
Code Action
E1
Turn the power OFF and ON again
E2
Turn the power OFF and ON again
E3
Requires repair
E4
Requires repair
E5
Requires repair
E6
Turn the power OFF and ON again
E7
Turn the power OFF and ON again
ERROR CODES
When applied torque exceeds capacity an
E
appears on the display
along with LED and audible alerts. Press and release the
+/C
button to
clear the error.
If an error code appears after the screwdriver is turned ON with
flashing LED and intermittent beep, refer to the following table.
11
Note:
E1, E2 and E6 may appear
when using the driver near
strong electromagnetic sources.
Turn the power OFF and move
away from them. If the condi-
tion persists the screwdriver
may need to be repaired.
REPAIR & RECALIBRATION
Go to www.imada.com and click on Repair/Calibration. Fill out the
form to receive an RGA number. Or call and send your unit to
Imada, Inc., Suite 707, 3100 Dundee Rd., Northbrook, IL 60062
12
