ILVE V09CSV/SS, Руководство пользователя, по эксплуатации и установке

Страница: 15 / 32

12
This appliance shall be installed only by authorised persons and in accordance
with the manufacturer’s installation instructions, local gas fi tting regulations, muni-
cipal building codes, electrical wiring regulations, AS/NZS 5601 - Gas Installations
and any other statutory regulations.
Warning: the appliance is not suitable for connection with a fl exible hose as-
sembly.
There are two ways to carry out the connection to the main gas line:
A. The cooker can be connected with rigid pipe as speci fi ed in AS/NZS 5601.
B. The cooker can be connected with an Australian approved Limited Flexibility
Connector which complies with AS 4631. The Limited Flexibility Connector used
must be long enough to allow the appliance to be pulled forward when service
is required. Ensure the connector is not subjected to abrasion, crushing or kin-
king during installation and that it is clear of the fl oor when the cooker is in the
installed position. A restraint device (typically chain) must be fi tted by the instal-
ler. The device must restrict the appliance movement to no more than 80% of
the Limited Flexibility Connector length to prevent strain on the gas connections
when the cooker is pulled forward.
The cooker is factory fi tted with two chains at the rear of the appliance (one on
the left side and one on the right side) to prevent the appliance from tilting forward.
The installer must connect the chains to the wall, directly behind the chains as low
as possible using a method that suits the wall material and restrains the weight of
the cooker. If the appliance is installed between two cupboards, the installer should
drill a hole on each side of the cupboards, pass the chains through the holes and
anchor the chains within each cupboard.
Important: After fi xing the chains ensure they are taut and test that the cooker
does not tilt forward or sideways.
Check all connections for gas leaks with soap and water. DO NOT use a naked
fl ame for detecting leaks. Ignite all burners both individually and concurrently to
ensure correct operation of gas valves, burners and ignition. Turn gas taps to low fl
ame position and observe stability of the fl ame for each burner individually and
concurrently. When satis fi ed with the hotplate, please instruct the user on the cor-
rect method of operation. In case the appliance fails to operate correctly after all
checks have been carried out, refer to the authorised service provider in your area.
The ovens are supplied to function as indicated on the plate. Should a change be
necessary you should proceed with the adaptation to another gas as described in
the paragraph “Burner regulation”.
The Data Label is located in the appliance door recess. This appliance is suitable
for Natural Gas and Universal LPG; ensure that the available gas supply matches
the Data Label.
Any adjustment, maintenance, etc. must be performed by an authorized techni-
cian after disconnecting the unit from the mains and from the gas supply.
INSTRUCTIONS
FOR INSTALLATION
Gas connection
Anti-tip device
Before leaving
Adapring for other gas
types
Data label