LiftLyte Operating Manual - DCNMAN101814 Rev. 3
3
Figure 1: LiftLy
te™ Main Components
Installation Procedure
Before starting the installation of the LiftLyte
™, understand that you will be providing power and the electrical power
cord to the LiftLyte. Determine the best location that will allow for the easiest power access. Also note that your
electrical extension cord may rise and fall with your lift depending on where you mount the AC Transformer Power
Supply. Always keep your power cords in an area where they will not be damaged in any way.
Note
:
All installation procedures must be performed with the power disconnected. The Procedures below
primarily pertain to the double stick tape version of the LiftLyte but serves as a guide for installation of
the magnetized version which is basically plug and play.
The LiftLyte
™ is designed to accept power from either the left or the right. The AC Transformer Power Supply (item 2)
may be positioned on the opposite side from that shown in Figure 1.
1.
Verify all parts and associated quantities to the list of provided components on page 2. If there are any
discrepancies please contact Illuminating Perception.
2.
Remove the LED Light Strips from their plastic packaging. NOTE their triangular shape. NOTE also that one
side has double stick tape pre-attached or magnets. Each LED Strip has a power input end and a terminated
end. (See figure 1) The power input end of each strip is placed on the lift end where the electrical power is to
be supplied.
3.
IMPORTANT
: The LED Light Strips must be attached at the proper angle when installed on your vehicle lift.
Placement of each strip is critical. (
The high quality tape used to attach the LED Light Strips is almost
impossible to remove when installed properly.
) The light emitted from the LED Strip must be directed under
and across the underside of the vehicle (See Figure 2). The magnetized version can be moved to determine
the most effective illumination.
Figure 2: Correct Angle of Light Output When Attached to Lift Runways
