Ilford Sportsview, Инструкция

Страница: 4 / 12

H O W T O
U S E Y O U R
S P O R T S V I E W PROJECTOR
Electrical connections
For electrical safety, use an earthed supply for your Sportsview
Projector. Connect the leads to a suitable three-pin plug, making sure
the green (earth) wire is properly connected.
A lamp switch (7) is fitted at the back of the projector and a red
dot is exposed when this is switched on. When not in use, the Sports-
view Projector should be disconnected from the mains supply.
The Lamp
A type A1/182 lamp is supplied with the Sportsview Projector. Make
sure it is of the correct voltage for the mains supply in your area.
If it is not, DO NOT USE THE LAMP, but consult your Ilford
Photographic Dealer.
Before you insert the lamp, make sure the projector is disconnected
from the mains supply.
Remove the lamp-house cover (1) by lifting from the front.
Insert the lamp into the lamp-holder and push it right home. (The
lamp-holder has been designed so that the lamp can only be fitted
in the correct position.)
Replace the lamp-house cover by positioning the back against the
supporting lugs and then snapping the front into place.
When the lamp is hot, the filament is easily damaged, so take care
not to knock the projector when it is switched on as this may shorten
the life of the lamp. After switching off, allow the lamp to cool for a
few minutes before moving the projector.
WARNING
The lamp is cooled by convection, and ventilation holes are provided
underneath the projector as well as on top. Standing the projector
on a cushion, or allowing these holes to become obstructed in any
other way will cause overheating, and may result in serious damage.
4