IKUSI TM70 Series, Руководство по обслуживанию

Страница: 6 / 27

I K U S I
6
21/05/2008
1. Without power, remove the EP70
EEPROM module from the receiver.
6th Push
button
6th Push
button
CHART 3
CHART 3
1. Without power, remove the EP70 EEPROM
module from the receiver.
1. Without power, remove the EP70 EEPROM
module from the receiver.
2. Introduce the EP70 EEPROM module, removed
from the receiver, in the spare transmitter.
2. Introduce the EP70 EEPROM module, removed
from the receiver, in the spare transmitter.
3. Introducing the battery, turn on the key to the ON
position and push and pull the Stop push button.
The LED will light in orange-green, it will make some
blinks in green colour during 15 seconds and it will
get extinguished.
3. Introducing the battery, turn on the key to the ON
position and push and pull the Stop push button.
The LED will light in orange-green, it will make some
blinks in green colour during 15 seconds and it will
get extinguished.
4. Press the 6
th
push button and Start at the same time.
Keep both push buttons pressed while the LED blinks in
red. Once the LED blinks in orange, you can release both
push buttons and the LED will lit in green.
4. Press the 6
th
push button and Start at the same time.
Keep both push buttons pressed while the LED blinks in
red. Once the LED blinks in orange, you can release both
push buttons and the LED will lit in green.
5.Very important thing . Without stopping the
transmitter, remove the EP70 EEPROM module.
When concluding the process, this removed EP70
EEPROM should be placed in its location in the
receiver.
5.Very important thing . Without stopping the
transmitter, remove the EP70 EEPROM module.
When concluding the process, this removed EP70
EEPROM should be placed in its location in the
receiver.
6. Introduce the blank EP70 EEPROM module in
the spare transmitter and tighten the two screws.
6. Introduce the blank EP70 EEPROM module in
the spare transmitter and tighten the two screws.
7. Press the 6
th
push button for about 5 seconds.
The LED will flash in orange. When finishing the
Process, the LED will get extinguished. The spare
transmitter is already programmed.
7. Press the 6
th
push button for about 5 seconds.
The LED will flash in orange. When finishing the
Process, the LED will get extinguished. The spare
transmitter is already programmed.
8. In order to start working, push and pull the Stop push
button . The LED will light an instant in orange-green, it
will make some blinks in green colour during about 15
seconds and it will get extinguished.Pressing Start push
button the system will start to work.
8. In order to start working, push and pull the Stop push
button . The LED will light an instant in orange-green, it
will make some blinks in green colour during about 15
seconds and it will get extinguished.Pressing Start push
button the system will start to work.
SPARE TRANSMITTER PROGRAMMING
(USING RECEIVER EP70)
SPARE TRANSMITTER PROGRAMMING
(USING RECEIVER EP70) C10