Ikra HEKS 2000, Руководство по эксплуатации

Страница: 15 / 72

GB-3
Technical Specifications
Model
HEKS 2000
Rated voltage V~ 230
Rated frequency Hz 50
Rated power consumption W 2.000
Mains fuse (delayed action) A 16
Speed rpm 14360
Max. blower air output m 3 / min 52 - 64
Max. suction capacity m 3 / min 20
Bag volume l 35
Weigth without cable kg 10,5
Schalldruckpegel LpA dB(A) 90
Vibration max. m/s² < 2,5
Protection class II/VDE 0700
This device has a radio interference suppression according to: EN 55014-1, EN55014-2
Please wear ear protectors!
Leaf Blower-Vac / Patio Cleaner
Operative range
This wheeled vacuum/blower device mainly serves to
clean hard surfaces as paved paths, courtyards and
terraces. It is only suitable for vacuuming or blowing
dry, light materials as, e.g., grass, leaves, small twigs
and pieces of paper. The vacuuming of heavy materials
as, e.g., metal, stones, branches, broken glass, and wet
leaves is expressly excluded.
MOUNTING THE HANDLE
(Fig. 1)
1 To mount the handle use a screwdriver to remove
the two screws (A) from the chassis.
Attention: Do not loose the nuts!
2 Lead the handle tube and mains cable into the
chassis.
MAKE SURE NOT TO DAMAGE THE MAINS
CABLE.
3 Fix the handle by inserting the two screws (A) into
the provided holes and fasten them with a screw-
driver.
NOTE: DO NOT TIGHTEN THE SCREWS TOO
FIRMLY.
ATTACHING THE COLLECTING BAG
(Fig. 2 + 3)
1 Insert the lower part of the bag’s frame into the
supports at the rear end of the chassis.
2 Push the locking lever (B) of the bag in the handle
down, and hold it in this position.
3 Turn the bag’s frame into the correct position.
4 Let go of the locking lever to have the holding bracket
of the bag lock in place.
5 Loosen the locking ring (C) from the lower part of the
main handle, and slide it along the handle tube. At-
tach the locking ring (C) to the upper part of the bag’s
frame to lock the same.
BEFORE STARTING
(Fig. 4 + 5)
• Make sure that the handle is properly attached
and is firmly seated in the chassis (see Assembly
Instructions).
• Always make sure that the collecting bag is attached
to the wheeled vacuum/blower unit before you switch
on the device (both in vacuum and blower mode)
(see Assembly Instructions).
• Your wheeled vacuum/blower unit is controlled over
the on/off switch (2) (Fig. 4) at the handle. Make sure
that the switch is in ‘off’ position.