IKH XW011, Инструкция по эксплуатации

Страница: 35 / 40

35
Ensure that the riving knife is always correctly adjusted:
-
The top of the riving knife does not protrude more than approximately 20 mm from the
top tooth of the saw blade.
- The distance between the riving knife and the teeth of the saw blade is about 3-8 mm.
Mounting the blade guard (Fig. E)
- Place the guard (3) over the riving knife (4).
- Fit the blade guard to the riving knife.
Never saw without having the blade guard in place.
Using the dust extraction connection (Fig. F)
The dust extraction connection together with an external vacuum cleaner takes care of the dust ex-
traction of the working surface.
-
Slide the suction mount of a vacuum cleaner onto the connection (16).
If possible, always provide for proper dust extraction.
Mounting the mitre fence (Fig. G and H)
The mitre fence is used for straight cross-cuts or sawing mitre cuts. The guide fence can be mounted
both to the left and to the right of the saw blade.
-
Slide the guide fence (7) with the holder (50) into the slot (56).
Setting the guide fence for straight cross-cutting (Fig. G and H)
- Mount the guide fence.
- Set the protractor (54) at 90
°
.
- Set the guide fence so that the guide profile (53) is just out of reach from the saw blade (5).
- Tighten the knobs (52).
Setting the guide fence for mitre cutting (Fig. G and H)
The mitre angle is infinitely variable from 0-60
°
.
- Mount the guide fence.
- Set the desired mitre angle using the scale on the protractor (54).
- Set the guide fence so that the guide profile (53) is just out of reach from the saw blade (5).
- Tighten the knobs (52).
Assembling the parallel fence (Fig. I1 and I2)
The parallel fence is used for ripping. The guide fence has two profiles of various width. The guide
fence can be mounted both to the left and to the right of the saw blade.
-
Place a bolt (56) in each of the recesses (57) and fit a knob (58) on the screw thread.
- Fit the guide profile (55) to the guide (6). Choose slot (59) for the wide profile (Fig. I1) and slot
(60) for the narrow profile (Fig. I2).
- Tighten the knobs (58).
Setting the guide fence for ripping (Fig. J)
- Loosen the knob (61) and slide the guide fence (6) with the holder (62) in the guide rail.
- Set the desired distance using the scale (63) on the table top.
- Tighten the knob (61).
Setting the bevel angle (Fig. K and L)
The bevel angle is infinitely variable from 0-45
°
.
- Loosen the lock knob (13).