IKH XW011, Инструкция по эксплуатации

Страница: 33 / 40

33
6. Parallel fence
7. Mitre fence
8. Table extension, rear
9. Table extension, left
10. Table extension, right
11. Handle for bevel angle adjustment
12. Handle for saw blade height adjustment
13. Lock knob for saw blade adjustment
14. Scale for bevel angle
15. Support
16. Dust extraction connection
17. Push stick
MOUNTING (Fig. B1 and B2)
The machine can be set up in two ways: for use on a workbench (Fig. B1) and for use with the sup-
port (Fig. B2).
Mounting the machine for use on a workbench
The machine must be screwed to a workbench.
-
Mark the position of the mounting holes (18) on the workbench.
- Drill holes at each of the marked positions, adjusting the diameter and depth of the holes to the
screws used.
- Place the machine on the workbench and insert the screws into the mounting holes.
- Firmly tighten the screws.
Mounting the machine for use with the support
Follow the instructions below “Assembling the machine”.
Assembling the machine (Fig. C1)
Always use the following procedure, in the order given, when assembling the machine.
-
Mount the table legs (22).
- Mount the frame (20).
- Mount the short support rails (21).
- Mount the long support rails (19).
- Put the support straight up.
- Tighten all fasteners.
- Mount the machine on the support.
- Mount the guide rail (23).
- Mount the handle for bevel angle adjustment (11).
- Mount the handle for saw blade height adjustment (12).
- Mount the table extensions (24).
Mounting the table legs (Fig. C2)
- Hold the first leg (25) in place at one corner of the first short rail (26) and fit using the fasteners
(27).
- Do not completely tighten the fasteners.
- Mount the second leg at the other corner of the rail.
- Fit the other legs according to the same instructions to the other rail.
Mounting the frame (Fig. C3)
- Hold the first long rail (28) in place between the table legs and fit using the fasteners (29).