IKH XW011, Инструкция по эксплуатации

Страница: 34 / 40

34
- Do not completely tighten the fasteners.
- Mount the other rail according to the same instructions.
Mounting the short support rails (Fig. C4)
- Hold the first rail (30) in place between the table legs and fit using the fasteners (31).
- Do not completely tighten the fasteners.
- Mount the other rail according to the same instructions.
Mounting the long support rails (Fig. C5)
- Hold the first rail (32) in place between the table legs and fit using the fasteners (33).
- Do not completely tighten the fasteners.
- Mount the other rail according to the same instructions.
Mounting the machine to the support (Fig. C6)
- Place the machine on the support.
- Place the fasteners (34).
- Tighten the fasteners.
Mounting the guide rail (Fig. C7)
- Hold the guide rail (23) in place against the front of the table top (2) and fit using the fasteners
(35).
- Tighten the fasteners.
Mounting the handle for bevel angle adjustment (Fig. C8)
- Place the handle (11) on the spindle (36).
- Fasten the set screw (37) against the flat side of the spindle.
Mounting the handle for saw blade height adjustment (Fig. C9)
- Place the handle (12) on the spindle (38).
- Fasten the set screw (39) against the flat side of the spindle.
Mounting the table extensions (Fig. C1, C10 and C11)
Use the long support braces (40) for mounting to the rear of the machine. Use the short support
braces (41) for mounting to the sides of the machine.
-
Hold the table extension (42) in place against the table top (2) and fit using the fasteners (43).
The table extension should fit tightly against the table surface.
- Do not completely tighten the fasteners.
- Hold the first brace in place against the housing and fit using the fasteners (44).
- Fit the brace to the table extension.
- Tighten the fasteners (45).
- Mount the other brace according to the same instructions.
Mounting and adjusting the riving knife (Fig. D and E)
- Bring the saw blade (5) to its highest position.
- Remove the table insert (46).
- Loosen the allen screws (47) a few turns.
- Place the riving knife (4) between the bracket (48) and the clamping plate (49) over the screw
thread.
- Adjust the riving knife correctly.
- Tighten the allen screws.
- Replace the table insert.