Ikegami OCP-100, Руководство по эксплуатации

Страница: 27 / 46

3.3.3 ABB (Auto Black Balance) 3.3.3 ABB (Auto Black Balance)
PANEL
ENABLE
MASTER
VF
POWER
HEAD
LINK
COLOR / PAGE PM IND
ENG FILE
LOAD
SKIN HUE QUICK START AWB ABB
CAP BARS CAL SUPER V
SUPER KNEE MATRIX
F
2
F
1
ON VAR.
E D C B A 5 4 3 2 1
STORE
1 2 3 4
5 6 7 8
HOLD MENU
BLK STRETCH
1 2 3 L H M
ON
+ 3 + +
3 7 11 3 7 11
（ % ）
GAMMA
C.TEMP
VAR.
GAIN （ dB ）
DTL
SOFT
DTL
SKIN
SHUTTER
ON
ND EFF CC
HEAD
MODE SWITCH
FILTER
AUTO SETUP
HEAD
CCU
OPT LEVEL
POWER
CAM
POWER
ABB switch
OCP
CAL switch → “ OFF ”
1 Set the CAL switch to “OFF”.
2 Press the ABB switch. The CAP state is set automatically, and auto black balance is executed. The auto black balance can be
canceled by pressing the switch again.
3 When auto black balance completes, the lamp goes off. If it did not complete normally, the lamp
fl
ashes.
“OK” or “NG” will be displayed on the VF window. If “NG” is displayed, press the ABB switch again to clear the NG state.
After removing the cause, repeat from step 2 .
If the R/G/B FLARE controls and MASTER PEDESTAL control on the OCP are not at their center positions, only one side of
the control may be effective as a result of ABB. The one-sided control can be corrected by setting the VR back to the center
position while pressing the KNOB FREE button.
To execute ABS, press the QUICK switch and then the ABB switch. AUTO BLACK SHADING will be executed.
PED, BLACK SET and BLACK SHADING are executed for the AUTO BLACK SHADING. (PED and BLACK SET are also
executed when auto black balance is executed.)
3. OPERATION 3-7
OCP-100 1209 VOL1 (U) (E) OCP-100