Ikegami Editcam 3 DNS-33W, Руководство по эксплуатации

Страница: 55 / 160

DNS-33W 0503 VOL1 (E) DNS-33W
3. INSTALLATION AND CONNECTION 3 - 7
■
Removing and Attaching the Eyepiece
This section explains how to remove the eyepiece from the
VF.
1. Pull out the Eyepiece Release Lever and turn the eyepiece
to the direction of the arrow to unlock the eyepiece.
Eyepiece Release Lever
Pull
2. Remove the eyepiece.
[Attaching the eyepiece]
This section explains how to attach the eyepiece on the VF.
1. Insert the eyepiece as △ mark on the VF and △ mark on
the eyepiece aligns.
2. Turn the eyepiece to the direction of the arrow until it
clicks into position. When the eyepiece is locked, it
clicks.
mark
3.5 Connecting a Microphone
This section explains how to connect a microphone to the
camera.
3.5.1 Connecting a Front Microphone
1. Check that the microphone holder is attached to the VF.
If it is not attached, attach a microphone holder to the
microphone holder attaching mount. Various microphone holder
options are available depending on the size of the microphone.
2. Loosen the screw on the microphone holder to open it.
3. Put the microphone in the opened microphone holder and
tighten the screw to secure it in place.
Camera Front Side
Screw
Microphone Holder
Close
Open
Microphone
4. Set the microphone switch according to the type of
microphone used.
While the microphone is connected to the MIC connector
on the front of the camera, the microphone switch
operation cannot be performed.
5. Connect the microphone cable to the MIC connector on
the front of the camera, and insert the cable into the cable
clamp to remove any slack.
Insert the connector until it clicks into position. When the
connector is locked, it clicks.
MIC IN
PRESET
AB12
P48
OFF
ATT
-20dB
OFF
POWER
MAINTE
MIC Connector
Microphone
Cable
Reference
For the settings of the microphone switches, refer to
"5.1 Microphone Power/Level Down Setting".