IKEA Anratta, Руководство пользователя

Страница: 8 / 56

ENGLISH 8
Settings
When the appliance is first plugged in it will ask you to set the
clock.
After a power failure the clock will flash and needs to be reset.
Your microwave oven has a number of functions which can be
adjusted to your personal taste.
G F A
1. Turn the
A
knob until Setting is shown (aprox. 3 sec).
2. Push the
G
knob out and turn it to choose one of the
following settings to adjust:
Clock, Sound, ECO, Brightness
3. Press the
F
button to exit the settings function and save all
your changes when you are done.
• Clock
G F
1. Press the
F
button (the left-hand digits hour’s flicker).
2. Push the
G
knob out and turn it to set hours.
3. Press the
F
button (the two right hand digits (minutes) flicker).
4. Turn the
G
knob to set the minutes.
5. Press the
F
button again.
The clock is set and in operation.
• Sound
G F
1. Press the
F
button.
2. Push the
G
knob out, and turn it to turn the buzzer ON or OFF.
3. Press the
F
button again to confirm the change.
• Eco
G F
1. Press the
F
button.
2. Push the
G
knob out and turn it to turn the ECO setting ON or
OFF.
3. Press the
F
button again to confirm the change.
When the ECO mode is on, the brightness of the display will
automatically switch to a lower level after 1 minute. If the ECO
mode is off, the brightness will switch to the same lower level
after 3 minutes. It will automatically switch back to the set
brightness level when a button is pressed or the door is opened.
• Brightness
G F
1. Press the
F
button.
2. Push the
G
knob out and turn it to set the level of brightness
suitable to your preference.
3. Press the
F
button again to confirm the change.
First use
Start protection / Safety lock
This automatic safety function is activated one minute after the
oven has returned to “stand by mode“. (The oven is in “stand by”
when the 24-hour clock is displayed or if the clock has not been
set, when the display is blank).
Open and close the door, then press
F
to start the function.
Cooling down
When a function is finished, the oven may carry out a cooling
procedure. This is normal. After this procedure the oven switches
off automatically.
The cooling procedure can be interrupted without any harm to
the oven by opening the door or pressing the
C
Button.
Setting the timer
Use this function when you need a kitchen timer to measure exact
time for various purposes such as cooking eggs or letting the
dough rise before baking etc.
G F A
1. Push the
A
knob out and turn it until zero position.
2. Push the
G
knob out and turn it to set the desired length of
the timer.
3. Press the
F
button.
An acoustic signal will be heard when the timer has finished to
count down.
Pressing any button to turn off the acoustic signal
WARNING : Overheating the liquid beyond boiling point can occur
without evidence of bubbling. This could result in a sudden boil
over of the hot liquid. To prevent this possibility the following
steps should be taken :
1. Avoid using straight-sided containers with narrow necks.
2. Stir the liquid before placing the container in the appliance and
let the teaspoon remain in the container.
3. After heating, allow standing for a short time, stirring again
before carefully removing the container from the appliance.
Jet start
This function is used for quick reheating of food with a high water
content such as; clear soups, coffee or tea.
With the knob in the upright postion, press Start button to switch
on the Jet Start function.
Jet Start automatically starts with full microwave power level
and the cooking time set to 30 seconds. Each additional press
increases the time with 30 seconds.
You may also alter the time by the Adjust knob to increase or
decrease the time.
Press the
F
button to confirm the cooking time.
Daily use