6. Materials used:
To assemble this model you will need:
Hobby knife
Sander
Screwdriver (Phillips #1 and small slotted)
Hex wrench 1x1.5 mm - 2x2 mm - 1x2.5 mm
Needle nose pliers
Bladegauge, Order No. 603445
Nut driver 4mm - 4.5 mm - 5 mm - 5.5 mm
Bowls for small parts
Cyano glue
Screwlock, Order No. 320006
-
-
-
-
-
-
-
-
-
-
7. Abbreviations:
To make the manual clearly and short we shall use certain abbreviations as follows:
8. Screws:
Most screws in this kit have metric threads and are described in the following way:
Head
Diameter
Length
Your special attention is
required!
Use cyano glue!
Assemble the shown
quantity!
Assemble the left side
the same way as the
right side.
Use some oil.
Use screw lock as
shown.
The part shown is not
included in this kit.
The subject is shown in
true scale.
The part has to move
easily without any
friction.
Different heads are used:
Caphead (CH), Lenshead (LH), Countersunk (CS), Roundhead (RH), phillips or
slotted types
M4x20 mm CH means 4 mm metric thread, 20 mm length with a cap head.
Tighten the crews very carefully. Do not use too much force and avoid damaging the
material.
