•
System units: Sets Ikarus OSD to use the international metric system or imperial measuring
system.
Metric
Imperial
Altitude
meters
feet
Distance
meters
miles
Speed
Km/h
mph
Soaring rate
No units
No units
Amp rate
Km/Ah
Mi/Ah
•
Low Battery Alarm(cell): Indicates when any battery reaches a voltage per cell below what’s
indicated. For the correct operation of the alarm, the cells number of each battery must be
properly configured.
•
Distance Alarm: Once we pass the settled longer distance, the distance indicator will start
flashing, indicating that we are too far, with the consequent risk of model loss due to poor
reception, insufficient battery, etc.
•
Low Altitude alarm: Below this altitude, altitude indicator will start flashing indicating that we
fly too low.
•
Low Speed Alarm: Below this speed, the speed meter indicator will start flashing indicating
that flew very slowly with the risk of stalling. Note that this measure is obtained from the GPS,
so it does not indicate the real aerodynamics speed, but the speed over ground, being affected
in case of flying with wind.
•
Waypoint Range: Indicates how far should approach to the waypoint before considering has
been achieved and move to the next waypoint. The plane will not go to the next waypoint, even
it has reached that distance, while still approaching waypoint.
•
After route ends: Indicates what action must take the plane once it has reached the last route’s
waypoint. The options are Going Home, Repeat (round route), Reverse (Go and return) or
Repeat.
•
Relative Altitude: Indicates whether to use absolute altitude provided by GPS, or use ground
level altitudes. In this case (check-box selected) it minus the home altitude to the current GPS
reading.
•
Home Latitude: Latitude home coordinate. Shown in degrees and decimal degrees. Positive
values correspond to the northern hemisphere and negative to the southern hemisphere.
•
Home Longitude: Longitude home coordinate. Shown in degrees and decimal degrees. Positive
values correspond to longitudes to the east of meridian 0 (Greenwich) and negative to the west.
•
Home Altitude: Indicates the home altitude or flying field altitude. Used to determine the
altitude of the ground where the plane takes off.
•
Update Firmware: Go to the OSD firmware update screen.
© Ikarus Team Sevilla 2010
Page. 17/60
