Please unpack the machine carefully and inspect for damage. It is
important that any transit damage should be noted at the time of
unpacking. In certain circumstances it may be necessary to in-
vestigate immediately (post, rail or freight forwarder).
The guarantee covers: the RW11 basic stirring motor in accordan-
ce with the type ordered, one connection cable, one blade stirrer
(160 mm in length), one mounting rod and the Operating
Instructions.
You have purchased a high-quality product in this device. Problem-
free operation is ensured as a result of its convenient form and sim-
ple handling characteristics. The materials which were used and
their precise identification allow and significantly simplify recycling
and the reuse of parts.
The speed-controlled, two-pulse EU external rotor motor makes infi-
nite settings of the rotational speed possible in a range from 0 to
2000 RPM. The electronic motor regulation maintains the set speed
at a constant, even with slight increases in viscosity.
Check whether the voltage given on the type plate corresponds
to the available mains voltage. Before beginning operation, be sure
that the knob for setting the rotational speed is set completely to
the left stop. If not, the device will begin to run at the last rotational
speed setting.
If these conditions have been met, the machine is ready to ope-
rate when the mains plug is plugged in. If these conditions are
not met, safe operation is not guaranteed and the machine could
be damaged
Observe the ambient conditions (temperature, humidity, etc.) listed
under Technical Data.
The output shaft is designed as a plug-in coupling in order to allow the
quick changeover of the stirrer tools. The stirrer tools must have a
shaft diameter of 4 mm in order to ensure that they are properly held
by the plug-in coupling.
The stirrer RW 11 basic are maintenance-free. It is subject only
to the natural wear and tear of components and their statistical
failure rate.
When ordering spare parts, please give the manufacturing
number shown on the type plate, the machine type and the
name of the spare part.
Please send in equipment for repair only after it has been cleaned and
is free from any materials which may constitute a health hazard. Use
only cleansing agents which have been approved by IKA to clean IKA
devices. To remove
use:
Dyes
isopropyl alcohol
Construction materials
water containing tenside / isopropyl alcohol
Cosmetics
water containing tenside / isopropyl alcohol
Foodstuffs
water containing tenside
Fuels
water containing tenside
For materials which are not listed, please request information from
IKA. Wear the proper protective gloves during cleaning of the devices.
Electrical devices may not be placed in the cleansing agent for the
purpose of cleaning.
8
RW11 0497
Output shaft
Useful details
Maintenance and cleaning
Commissioning
Unpacking
RW 11 07.12.2000 15:58 Uhr Seite 8
