IKA KS 4000 i control, Руководство по эксплуатации

Страница: 24 / 84

24
An error is indicated by an acoustic signal and an error code is dis-
played.
E.g.:
Note:
During continuous operation, the load may slip, for example, resul-
ting in the appliance becoming excessively unbalanced. To pre-
vent this, there is a motion sensor built in which reduces the
speed gradually once a critical limit has been reached.
When faults are not specified in the table, you switched the
appliance off and again on.
If faults cannot be eliminated directly, you must perform a
RESET (see "Resetting parameters to the factory settings")!
If the faults still cannot be eliminated, the appliance must be
inspected by a technical service.
KS 4000 i 1208
Error codes
Water is the only coolant that may be used (with antifre-
eze, e.g. ethylene glycol).
Observe the maximum permissible pressure of 1 bar! As
a safeguard, we recommend using a pressure limiter (e.g.
IKA C25). This is not necessary when using an IKA
KV600.
Accumulated condensate is drained out of the cooler through the
drain hose.
3729600a_KS4000_122008:KS 130 b-c 28.01.2009 10:34 Uhr Seite 24