The clamping chuck and output shaft permit all standard
commercial stirrer tools up to 10mm diameter to be gripped and
screwed in. The opening on the top side of the housing is closed
with a slotted rubber diaphragm. It is, however, possible for stir-
ring shafts to push out over the top edge of the housing eg during
change of container.
If it becomes necessary - depending on the layout of the equip-
ment - to allow the shaft end to project over the edge of the hou-
sing during operations, the rubber diaphragm should be removed.
Instead a stirrer shaft cover, which can be obtained as an acc -
essory, must be placed on the housing. If the stirrer shaft cover
is removed again, the rubber diaphragm must be pressed into the
housing opening again so that this is closed. This is the only way
of ensuring safe working and preventing any fluids from penetra-
ting the equipment.
Please see section ”Safety Instructions”!
The stirrer is maintenance-free. It is subject only to the natural
wear and tear of components and their statistical failure rate.
When ordering spare parts, please give the manufacturing
number shown on the type plate, the machine type and the
name of the spare part.
Please send in equipment for repair only after it has been clea-
ned and is free from any materials which may constitute a
health hazard. Only use water with a detergent additive contai-
ning a surfactant for cleaning, or for heavier soiling isopropylal-
cohol.
R 1822
Fixed plate
RH 1
Tension-holder
R 181
Cross-sleeve
FK 1
Flexible connection
DZM 1
Speedometer; RLS 8 x 33
Speed range under nominal load:
min
-1
40-1200
Max. stirrer speed:
Ncm
40
Permitted switched-on time:
%
100
Speed setting:
Speed adjuster with pulse width modulator
Speed indicator:
Scale on knob
Nominal voltage:
VAC
230
±10%
EURO
VAC
115
±10%
USA
Frequency:
Hz
50 / 60
Input power:
W
75
Output power:
W
55
Output on stirrer shaft:
W
53
Total efficiency:
0,71
Protection type to DIN 40 050:
IP42
Excess voltage category:
II
Degree of pollution:
2
Overload protection:
El. current limitation
Fuses (on mains plate):
A
4 T (IKA ident.no. 25 851 00)
13
RW160995EU
Output shaft
Maintenance and cleaning
Accessories
Technical data
Protection measures:
0
Class
Protection device
Recommended use
0
No additional protection Used only on equipment where
failure of the controls does
not represent a hazard.
The operating conditions should be monitored at regular intervals.
Содержание 25 510 00
Страница 3: ...3 RW160995EU IKA RW16 1 10 9 2 3 8 4 7 5 6 LABORTECHNIK basic 0 A C B Fig 1 Z Y X Fig 2...
Страница 4: ...4 RW160995EU...
Страница 65: ...65 RW160995EU...
