SuperiorFireplaces.us.com
900463-01E
28
VARIABLE REMOTE MODELS OPERATION
Continued
Figure 43 - Hand-Held Remote Control
ON/OFF
MODE
UP/ DOWN
Arrows
THERMOSTAT
LCD Display
FLAME HEIGHT
This function allows you to control height of
fl ames through 5 levels
(see
Figure 44
)
.
Select
manual fl ame height function by pressing MODE
button until a fl ame is shown in lower left corner of
display. Use UP/DOWN arrow button to set desired
fl ame height
(see
Figure 43
)
. A beep from receiver
confi rms the command.
SMART THERMOSTAT
The Smart Thermostat adjusts fl ame height in ac-
cordance to differences between set temperature
and room temperature. As room temperature gets
closer to set temperature the smart function will
modulate the fl ame lower. As room temperature
cools, it will modulate the fl ame higher.
ON
ON
MAX
Figure 44 - Remote Control Display of Flame
Height Minimum and Maximum
MINIMUM
MAXIMUM
ON
Figure 45 - Room Temperature Setting
Room
Temperature
Set Temperature
ROOM THERMOSTAT
The remote control can operate as a room thermo-
stat. The thermostat can be set to a desired tem-
perature to control the comfort level in the room.
To activate, press THERMOSTAT button on remote
control
(see
Figure 43)
. The word ON will appear
to the right of temperature bulb graphic on display
(see
Figure 45
).
Use UP/DOWN arrow button to set
desired room temperature. Control system will cycle
fi replace on or off to maintain selected temperature.
WARNING: Fireplace can turn on
suddenly. Keep away from burner.
After lighting pilot, let pilot fl ame burn for about
one minute. Slide remote selector switch to RE-
MOTE position. You can now turn burner on and
off with remote.
IMPORTANT:
Do not leave selector switch in
REMOTE or ON position when pilot is not lit. This
will drain batteries.
When any button is pushed on remote control,
LCD display will glow blue. Blue glow will go off
after several seconds if no action is being taken
with remote.
ON/OFF
Push ON/OFF button and burners will come on in
high position
(see
Figure 43
).
An acoustic signal
from the receiver confi rms the command.
Push ON/OFF button again and burners will turn
off.
A beep from receiver confi rms the command.
OPERATING REMOTE CONTROL
