SuperiorFireplaces.us.com
900463-01E
26
VARIABLE REMOTE MODELS OPERATION
Continued
Figure 38 - Control Knob and Igniter
Button Location
O
F
F
P
ILO
T
O
N
Control Knob
Igniter Button
7. With control knob pressed in, press and release
igniter button. This will light pilot. The pilot is
attached to the front burner. If needed, keep
igniter button pressed in until pilot lights.
NOTE
: If pilot does not stay lit, contact a quali-
fi ed service person or gas supplier for repairs.
Until repairs are made, light pilot with match.
To light pilot with match, see Manual Lighting
Procedure,
Page 27
.
8. Keep control knob pressed in for 30 seconds
after lighting pilot. After 30 seconds, release
control knob.
• If control knob does not pop out when re-
leased, contact a qualifi ed service person or
gas supplier for repairs.
NOTE
: If pilot goes out, repeat steps 4 through
8.
9. Slightly push in and turn control knob
counterclockwise
to the ON posi-
tion.
10. Wait one minute and switch selector switch
to the ON position to light burners
(see
Figure 39
)
. When using in the ON position
(without remote) burners will light on high.
There is no adjustment to the fl ames without
using remote.
11. To leave pilot lit and shut off burners only, turn
control knob clockwise
to the PILOT
position, or use remote control manual OFF
button, or set selector switch in the OFF po si-
tion.
Figure 39 - Remote Selector Switch in ON
Position
ON REMOTE OFF
PRG
NOTICE: During initial operation of new
appliance, burning logs will give off
a paper-burning smell. Orange fl ame
will also be present. Open damper or
window to vent smell. This will only
last a few hours.
LIGHTING
INSTRUCTIONS
1. STOP! Read the safety information, column 1.
2. Make sure equipment shutoff valve is fully
open.
3. Set remote selector switch in OFF position.
WARNING: Burners will come
on automatically within one minute
when the selector switch is in the ON
position after the pilot is lit.
CAUTION: Do not try to adjust
heating levels by using the equipment
shutoff valve.
4. Press in and turn control knob clockwise
to the OFF position.
5. Wait fi ve (5) minutes to clear out any gas.
Then smell for gas, including near the fl oor. If
you smell gas, STOP! Follow “B” in the safety
information, column 1. If you don’t smell gas,
go to the next step.
6. Press in and turn control knob counterclock-
wise
to the PILOT position. Press in
control knob for fi ve (5) seconds
(see
Figure
38
).
NOTE
: You may be running this appliance for the
fi rst time after hooking up to gas supply. If so,
the control knob may need to be pressed in for
30 seconds or more. This will allow air to bleed
from the gas system.
WARNING: Make sure the selector
switch is in the OFF position when
you are away from home for long
periods of time. Appliance will come
on automatically with selector switch
in the ON position.
