SuperiorFireplaces.us.com
900463-01E
24
REMOTE READY MODELS OPERATION
Continued
NOTE
: AUTO is only functional when using
GWMT1 or GWMS2 optional accessories. If
hand-held remote control is installed but not
being used, slide remote selector switch to ON
(It must be in this position for burners to light.
Switch will be in REMOTE position if using
hand-held remote).
11. Set fl ame adjustment knob to any level between
HI and LO.
12. To leave pilot lit an shut off burners only: turn
control knob clockwise
to the PILOT
position, or use remote control manual OFF but-
ton , or set selector switch in the OFF position.
Figure 36 - Pilot (Natural)
Igniter
Electrode
Pilot Burner
Figure 35 - Control Knob, Igniter Button and
AUTO/OFF/ON Switch
6. Press in and turn control knob counterclock-
wise
to the PILOT position. Press in
control knob for fi ve (5) seconds
(see
Figure
35
)
.
NOTE
: You may be running this appliance for
the fi rst time after hooking up to gas supply. If
so, the control knob may need to be pressed
in for 30 seconds or more. This will allow air
to bleed from the gas system.
7. With control knob pressed in, press and release
igniter button on left side of log set. This will
light pilot. The pilot is attached to the front
of U-shaped burner. If needed, keep pressing
igniter button until pilot lights.
NOTE
: If pilot does not stay lit, contact a quali-
fi ed service person or gas supplier for repairs.
Until repairs are made, light pilot with match.
To light pilot with match, see Manual Lighting
Procedure,
Page 25
.
8. Keep control knob pressed in for 30 seconds
after lighting pilot. After 30 seconds, release
control knob.
• If control knob does not pop out when re-
leased, contact a qualifi ed service person or
gas supplier for repairs.
NOTE
: If pilot goes out, repeat steps 4
through 8.
9. Slightly push in and turn control knob counter-
clockwise
to the ON position. If using
a hand-held remote control accessory, go to
Optional Hand-Held Remote Operation
on
Page
25
.
10. Wait one minute and put switch in ON position
to light burners.
AUTO
OFF
ON
Selector Switch
Control Knob in
OFF Position
Flame
Adjustment
Knob
Igniter
CAUTION: Do not try to adjust
heating levels by using the equipment
shutoff valve.
WARNING: Make sure the remote
selector switch is in the OFF position
when you are away from home for long
periods of time. Appliance will come
on automatically with selector switch
in the ON position.
