-
15
-
www.igmtools.com
2. Locate the side supports labelled on the inside with “L” and “R”.
Front side
Pic. 8
Back side
Pic. 9
3. The base below shows where each side support needs to go.
Pic. 10
4. Place the Long side support labeled “L” in an upright position with the
slant facing inwards towards the middle of the base. The angle of the
picture below has been taken on the opposite side to show the label “L”.
four bolt holes facing up.
Pic. 4
4. For each wheel, insert bolt from caster through the holes in the base.
Tighten the caster and do the same for the rest.
Pic. 5
Pic. 6
SIDE SUPPORTS
1. Place the base with the casters on the bottom. Make sure you place the
side with the two bolt holes on each leg of the base to your right side when
looking down on it.
Pic. 7
A
Obr.
1
Obr.
2
LONG R
SHORT R
SHORT L
LONG L