-16-
www.igmtools.com
Rys. 11
5. Align the two holes in the bottom end of the long side support with the
two holes in the base. Use screws (8 mm x 19 mm) and flast washers to
align (8 mm). Tighten the bolt securely.
Rys. 12
6. Place the short side support labelled “L” in an upright position with the
slant facing long side support.
Rys. 13
7. Align the two holes on the top end of the short side support to with the
two bolt holes on the middle of the long side support. Screw together
using hex bolts (8 mm x 19 mm) and washers (8 mm). Tighten securely.
8. Align the two holes on the bottom end of the short side support to the
two bolt holes in the base. Screw together using hex bolts (8 mm x 19
mm) and washers (8 mm). Tighten securely.
Rys. 14
9. Repeat this process for the remaining side supports labelled “R”.
10. The figure below shows both side supports assembled.
Rys. 15
11. Locate the support brace and place inside the two side supports.
Note: Make sure the support is attached to the side supports closest to
the motor.