IGM EMI-SSD-1M, Руководство по настройке

Страница: 19 / 49

I N T E R N A L C H A N N E L S S E T T I N G S
19
MRBP.424321.001G2 Version 1.0 15/06/2020
5 INTERNAL CHANNELS SETTINGS
To select internal channels settings, it is necessary to enter « MENU » → « CHANNELS SET-
TINGS » → « INTERNAL CHANNELS » .
The list of internal channels is shown in the « INTERNAL CHANNLES SETTINGS » menu. It is
possible to see brief information about a channel by using the buttons and : gas, measure-
ment units, position, channel state. After the channel selection, the channel settings menu is dis-
played.
CH1: TUNING
MAINTENANCE: DISABLED
CONFIGURATION
INPUT CALIBRATION
CHANNEL FACTORY DEFAULTS
The number of the channel is shown in the top left corner of the display (C1-C8).
In the « SETTINGS » menu it is possible to set/change the following channel settings:
•
« MAINTENANCE » - maintenance mode switching on/off;
•
« CONFIGURATION » - configuration change;
•
« INPUT CALIBRATION » - input calibration parameters change;
•
« CHANNEL FACTORY DEFAULT » - factory default settings.
5.1 CHANNEL MAINTENANCE MODE SWITCHING ON/OFF
At turning « MAINTENANCE » mode on any contingencies are bypassed, i.e. relay, sound and
LED signalizations don’t go off . This mode is intended for maintenance service or trouble-shooting of
the detector connected to the channel.
To switch on/off channel maintenance mode it is necessary to enter « MENU » → « CHANNELS
SETTINGS » → « INTERNAL CHANNELS » → « CHANNEL 0 Х» → « MAINTENANCE ».
CH1: MAINTENANCE