-
8
-
www.igmtools.com
Operating instructions EN
rotate side-wheel. (C)
Over-Arm elevation: Loosen Lever (D), rotate
TOP-Wheel. (E)
6.2 Control- Joint
Arm-bracket: Loosen 2 attached screws (F)
Angle Joint: Loosen Lever (G)
Motor clamp: Loosen Lever (H)
Machine body: Loosen quick release (I)
6.3 Feeding
Loosen Level (A), then swing the feeder aside then
locked the lever til tight
NOTE: Ensure there is sufficient weight support to
prevent power feeder tilted while Swing aside.
Loosen LEVER (B), rotate the machine to left side 90°
(vertical to the ground), rollers faced to right, motor
to left then lock the lever.
Loosen LEVER (C), rotate the machine 90° (Parallel to
the ground) power switch on top, roller at the bottom
the lock the lever.
Loosen LEVER (A), push the machine back to
worktable, postion the roller opposite to the guide
plate then lock the lever.
Lock all ther lever properly to complete the
adjustment.
NOTICE: The purpose of elevating kits tolerance gap is
to allow smooth operation while elevating the feeder;
Please pull back machine body to feed-in direction
after elevating adjustment and lock the hand lever to
tight at the meantime (A).
7. POWER CONNECTION AND GROUNDING
NOTE:
Read the motor specification to ensure
thepower source and voltage is compatible. (Range:
±5%)
Ensure power switch is (OFF) before connect the
power source.
Requirement:
• Connected to the repectively non-fuse circuit or
motor circuit breaker.
• The external power switch cord cannot be less than
12AWGl.
• Switch required wired in compliance with your
national or local electrical regulation.