www.igm.cz
28
Návod k obsluze CZ
Operating Instruction EN
www.igmtools.com
- Release the locking lever (B, pic.15) and set the
height of the feeder.
Warning
: Before releasing the lever (B), make sure you
are preventing the feeder to fall over. Otherwise, it can
suddenly fall and cause an injury or damage itself.
pic.15
- If you release the lever (C, pic.16), you can rotate the
feeder in the joint.
pic.16
Warning
: Always make sure all levers are properly
tightened before turning on the feeder.
6.1.1 Feeding from above
It is important that the feeder creates constant pressure
against the fence when feeding from above
pic.17a
view from above
pic.17b
side view
The difference between the distance of the feeder and
the fence should be greater on the infeed roller by 3-4
mm than on the outfeed roller (pic. 17b).
pic.18
1
2
7. OPERATING THE MACHINE
After switching the machine on, let the feeder reach
its full speed before feeding any material.
8. MAINTENANCE AND CONTROL
8.1Replacing rollers
Any adjustments and maintenance may be carried out
when the machine is disconnected from the power source.
Note:
The regular switch up of roller position grants longer life
of the rollers.
- The workpiece must be leaning on a guiding fence when
feeding.
Take off the front cover of the rollers. Remove the circlip (C,
pic.19) and remove the roller. Insert a new roller into the
original position. Mount the circlip (C).
- Use the D76x30 mm roller for the M3 Power Feeder.
(code: 141-R76)
6.1.2 Feeding from the side
- Release the lever (C, pic.16) turn the feeder to a
vertical position and tighten the lever (C).
The rollers must push the workpiece against the fence.
6.2 Controls
- The feeder has a switch (1), that indicates the feed
direction. The feeding is turned off when in the middle
position.
- The control wheel (2) is used to regulate the feed speed
within the range of 2-12 m/min.
- The control wheel can be used as a power switch, it will
halt the feed when pushed. Pull it to restart the feed.
