www.igm.cz
Návod na obsluhu CZ
25
www.igmtools.com
Operating Instruction EN
workpieces. Always switch off the feeder first,
only then switch off the machine that is being fed
material.
Always disconnect the power cord before any repairs
or adjustments.
4. SPECIFICATIONS OF THE MACHINE
4.1 Machine description
1 anchoring bolt
3 locking lever (arm angle/feeder height) 4 locking
lever (feeder rotation)
5 arm holder
6 control wheel of arm protrusion (turning moves the arm)
7 locking lever (arm protrusion) 8 feeder arm
9 motor
10 locking lever (joint of the feeder body)
11 feed roller
pic.2
Assemble before operating. Remove the edgebander
from the packaging and place on a flat surface. Check
for any apparent transport damages, these could
damage the machine or your health.
5.2 Assembly
5.2.1 Fastening to a machine
A) using a quick fit universal plate
- you can fasten the feeder to the machine using a
quick fit universal plate (not included), (pic.2).
B) Mounting to the top of a workbench
The feeder is supplied with a 1:1 template that
facilitates the mounting of the feeder onto a base
(Pic. 3).
1. Unpack the feeder base and adjust it according to
the mounting template.
2. Prepare 4 bolts and spring washers (not included).
Bolt size - M10, length = feeder base (thickness) +
table top (thickness)
3. Select position of the base to avoid ribbing on the
bottom of the table.
4. Place the template on the table, use a tape to hold
two sides of the template
5. Use a sharp object to mark out the holes and drill
them out.
4.2 Technical data
Motor power (230V)
95W
Arm reach
260mm
Max. workpiece height
150mm
No. of rollers
3
Size of rollers
76 x 30mm
Feed speed
2 - 12m/min
Weight with stand
10,5kg
4.3 The package includes
The M3M Power
Feeder,
Feeder Arm,
Feeder base
plan for base drilling
1:1
manuál
5. TRANSPORT, UNPACKING AND ASSEMBLY
5.1 Transport and unpacking
The machine is not assembled due to transport.
4
3
2
5
1
11
6
10
7
8
9
pic.1
B.1) Fastening with a nut through the table
1. Insert the screws with washers through the base
and the tabletop.
2. Tighten the nut to the table.
B.2) Fastening with a thread in the table
1. Use a screw cutter to drill out the holes.
2. Insert the screws with washers through the base
and screw it them into the tabletop.
