en
3
User manual Jamajka W OPEN
www.igloo.pl
3. PREPARING THE UNIT FOR OPERATION
3.1. Requirements for the installation site
•
Check whether the cross-section of power cables is suitable for the current consumption of the installed equipment
•
It is forbidden to connect the device via extension cables or distributors
•
The unit must be connected to a separate, properly prepared electrical circuit with a socket with protective pin
(as per PBUE)
The unit may only be started after confirming the effectiveness of shock protection with the results of
measurements carried out in accordance with applicable regulations!
3.2. Connection and start-up
•
Unpack the unit and remove the wooden pallet
•
Place the unit on a level and sufficiently solid surface, and then level it with the feet Fig.1/9 (p.3)
•
Remove protective film from the cabinet components
•
First cleaning of the unit
should be done after unpacking the unit and prior to start-up. The device should
be cleaned with water at a temperature not exceeding 40°C with added natural cleaning agents.
Cleaning
and washing of the device must not be done using agents containing chlorine and different varieties
of sodium, as they damage the protective layer and the unit’s components!
Any residual adhesive or
silicon on metal components may only be removed with petroleum ether (does not apply to plastics compo-
nents!). Do not use other organic solvents.
Do not use water jets while washing the unit. The unit should be cleaned with a damp cloth.
• Place the plug of the connection cable directly into the socket (it is forbidden to connect the device via
extension cables or distributors!)
• Switch on the main switch Fig.5/1 (p.7), which will turn on the thermostat, and then the generator unit
• In the thermostat panel Fig.5/3(p.7) set temperature a (detailed operation at
p.14 or 15)
• Press the lighting switch Fig.5/2 (p.7)
Once the unit has been installed at its destination, leave it at rest for at least 2 hours before switching on
(for equipment with internal generator unit), so that the oil level settles to prevent problems with starting the
chiller!
WARNING: Protect the cooling circuit against damage!
•
If the unit goes to the user partially disassembled for safety in transport, proceed as follows:
1.
Install the hooks with the lamp in the frame
2.
Fig.2/3 (p.5)
3.
Place glass shelves on the frame and the internal countertop Fig.4/5,6 p.6) . Place glass components on silicon
parts (bumpons) Fig.4/8 (p.6).
Fig.2 Mounting the hook on the frame
1
2
3
1 – Hook mounting holes
2 – Vertical pin of the internal frame
3– Hook (fitted for three-step adjustment of the suspension angle)
