IGBT MIG-200M, Руководство пользователя

Страница: 10 / 21

9
5.3 Filler Wire
5.3.1 Threading the filler wire
1. Open the reel housing by pressing on the opening button and install the wire reel in such a way
that it rotates counter clockwise. You can use either a 5 kg (diameter 200 mm) or l kg (100 mm)
wire reel in the machine.
2. Attach the reel with a reel lock.
3. Unfasten the wire end from the reel, but hold on to it all the time.
4. Straighten the wire end for approximately 20 cm and cut the wire in the straightened location.
5. Open the pressure control lever which then opens the feed gear.
6. Thread the wire through the wire's rear guide to the gun's wire guide.
7. Close the feed gear and fasten it with the pressure control lever. Make sure that the wire runs in
the feed roll groove.
8. Adjust the compression pressure with the pressure control lever no higher than to the middle of
the scale .lf the pressure is too high, it removes metal fragments from the wire surface and may
damage the wire. On the other hand, if the pressure is too low, the feed gear slips and the wire
does not run smoothly.
9. Press the welding gun trigger and wait for the wire to come out.
10. Close the reel housing cover.
CAUTION! When driving the wire in to the gun, do not point the gun at yourself or others or
put, for example, your hand in front of the tip, because the cut wire end is extremely sharp.
Also, do not put your fingers near the feed rolls, because they might get squeezed between
the rolls.