edgeController
15
4.3.3
Panel cutout
61280
► Make a cut-out.
1
4
9
,5
328
4 x R5
Panel cutout
Tolerances: ± 0.5 mm
>
4.3.4
Mounting steps
61281
► Screw the set screws into the M5 thread on the back of the device. (→
Location for mounting
accessories
(
► Attach damping strips to the device.
Damping strips
► Insert the device into the cut-out.
► Screw the fixing profiles to the back of the device. Tightening torque of the hexagon nuts: 5
±0.5
Nm
NOTICE!
Contact corrosion between the mounting screws and the housing.
>
Damage to the device
► Do not use copper or nickel-plated materials for the bolting elements.
► Use zinc-plated screws.
► In very corrosive environments such as extremely salty air, use screws with surface
finishing on a zinc/nickel basis with thick-film passivation and sealing.
