IFM Electronic Efector 160 LK1222, Руководство по эксплуатации

Страница: 56 / 75

4. Setting of the switching parameters
Set the parameters in the following order:
Setting values for OP
56
Press until the requested
parameter is displayed.
Mode/Enter Set
Press and hold until the
requested value is
indicated.
Mode/Enter Set
Confirm / return to the
menu.
Mode/Enter Set
LK1222
cm inch
6.9 2.7
8.2 3.2
9.4 3.7
10.6 4.2
11.8 4.7
13.0 5.1
14.3 5.6
15.5 6.1
16.7 6.6
17.9 7.1
19.1 7.5
20.4 8.0
LK1223
cm inch
13.9 5.5
16.3 6.4
18.8 7.4
21.2 8.3
23.6 9.3
26.1 10.3
28.5 11.2
31.0 12.2
33.4 13.1
35.8 14.1
38.3 15.1
40.7 16.0
LK1224
cm inch
20 8.0
24 9.5
28 10.9
31 12.3
35 13.8
39 15.2
42 16.7
46 18.1
50 19.5
53 21.0
57 22.4
61 23.9
OP
Overflow switch point : position of the measuring segment
used as overflow protection.
Please observe the installation instructions and the indicated
minimum distances, especially the distance between OP and
the medium (
→
page 52, 57).
Switch point : upper limit value at which the operating output
changes its switching status.
SP1
rP1 Reset point : lower limit value at which the operating output
changes its switching status.
OU1
Switching function for the operating output: 4 settings can be
selected: hysteresis ( H.. ) or window function ( F.. ), as
normally open ( .no ) or normally closed ( .nc ).
dr1
Switch-off delay for the operating output (only for hysteresis
function), setting range: 0 ... 5 s in steps of 0.2 s.