20
Setting or changing the parameter value
► Press [▲] / [▼] until the requested parameter value is
displayed (→ 8.2.3 Numerical entries).
CH1
RUN
0.0
DT1
CH1
RUN
15.0
DT1
CH1
RUN
1665
RPM
CH1
RUN
1
CH1
RUN PRG
0.0
DT1
CH1
RUN PRG
15.0
DT1
Acknowledgement of the set parameter value
► Press [Enter/►] until the parameter abbreviation no longer
flashes and the indicator PRG has disappeared�
> The new parameter value is indicated and effective�
CH1
RUN
0.0
DT1
CH1
RUN
15.0
DT1
CH1
RUN
1665
RPM
CH1
RUN
1
CH1
RUN PRG
0.0
DT1
CH1
RUN PRG
15.0
DT1
Return to the RUN mode
► Press [Enter/►] for about 3 s or wait for the time-out function
(approx� 15 s)�
> The unit is again in the RUN mode, the current value is
indicated�
CH1
RUN
0.0
DT1
CH1
RUN
15.0
DT1
CH1
RUN
1665
RPM
CH1
RUN
1
CH1
RUN PRG
0.0
DT1
CH1
RUN PRG
15.0
DT1
8.2 Notes on programming
8.2.1 RUN mode
During programming the unit internally remains in the RUN mode (RUN
indicator visible)�
This means that until a new value is acknowledged with [Enter/►], the
unit carries out its monitoring function on the basis of the previously set
parameters and switches the relay and transistor outputs accordingly�
The monitoring function of the monitor is deactivated by continuously
pressing [Enter/►] in the RUN mode. The deactivation is effective as long
as the button is pressed�
8.2.2 Time Out function
If during programming no pushbutton is pressed for approx� 15 s, this is seen as a
cancellation�
Parameter changes which are not acknowledged with [Enter/►] are rejected. The
previously set parameter value is restored and remains effective for the monitoring
functions�
8.2.3 Numerical entries
► Press [▲] or [▼] and hold it.
The smallest decade becomes active and is counted up or down depending on the
selected pushbutton (e�g� 1, 2, 3,���0)� Then comes the next decade, etc�
