IFM Electronic E2D400 Series, Руководство пользователя

Страница: 66 / 160

Page 56
E2D400 Series Panel PC
Figure 5-4: SO-DIMM Socket Location
Step 4: Remove the DDR memory module by pulling both the spring retainer clips
outward from the socket.
Step 5: Grasp the DDR memory module by the edges and carefully pull it out of the
socket.
Step 6: Install the new DDR memory module by pushing it into the socket at an angle
( Figure 5-5 ).
Step 7: Gently pull the spring retainer clips of the SO-DIMM socket out and push the
rear of the DDR memory module down ( Figure 5-5 ).
Step 8: Release the spring retainer clips on the SO-DIMM socket. They clip into place
and secure the DDR memory module in the socket. Step 0:
Figure 5-5: DDR SO-DIMM Module Installation
5.5.2 CF Card Replacement
The E2D400 series has one CF Type II slot. To replace the CF card, follow the instructions
below.
Step 1: Follow all anti-static procedures . See Section 5.2 .