IES Keywatt 19, Руководство пользователя

Страница: 32 / 36

www.ies-synergy.com
User Manual
DIM016199-EN
32
9. Cleaning
Clean the outside of the terminal can be done while it is on, however, do not clean the terminal when an elec-
tric vehicle is connected to the terminal.
Cleaning the terminal is made with a dry cloth or possibly soapy water, it is to do 2 times a year.
Cleaning with solvent should be avoided to ensure good behavior in time of painting.
I
CAUTION
RISK OF DAMAGE TO THE TERMINAL
• DO NOT use a high pressure jet to clean the device.
• Preserve the terminal from contact with gasoline, diesel and other automotive fluids.
• DO NOT use solvents to clean the terminal.
Failure to follow these instructions can cause damage.
Every six months,
• Conduct a visual inspection of the air inlet of the charging station and ensure that they are not clogged.
• Conduct a visual inspection of the charging cable and ensure that cable does not show any visual damage
or deformation.
• Conduct a visual inspection of the charging gun and ensure that gun does not show any visual damage,
arcing or rust.
Every year, conduct a visual inspection of the state of the lightning protections and ensure that they are not
damages.
I
WARNING
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
• To avoid danger of electrical shock or injury, turn off power at the panel board or load
center before working on the equipment or removing any component. Do not remove circuit
protective devices or any other component until the power is turned off.
• Disconnect electrical power to the harging station before any maintenance work to ensure
that it is separated from the supply of AC mains. Failure to do so may cause physical injury or
damage to the electrical system and charging unit.
• Maintenance of the charging station shall be conducted only by a qualified technician.
Failure to follow these instructions will result in death or serious injury.