3.3
I
NSTALLING
R
OLL
M
EDIA
3.3.1 Installing a Roll of Documents
IMPORTANT:
To install a roll of documents on the roll media
dispenser
(A),
the
heat
sensitive
layer
of
the
documents must be facing upwards.
1. Unlock the moveable flange (B) move to "UNLOCK" position) of
the roll media dispenser shaft (C).
2. Place a roll of documents (D) on the roll media dispenser shaft
(C) and push it against the moveable flange (B).
3. Move the roll of new documents (D) and the moveable flange
(B) along the roll media dispenser shaft (C) until the roll of
documents (D) is aligned with the paper intake (E), see figure
page 25.
4. When the alignment is satisfactory, lock the moveable flange
(move to "LOCK" position) (B) to immobilize the roll media
dispenser shaft.
Figure 3.3
Installing a roll of documents
IER 400B
User Guide
Page 24
N0C402B Rev. 1
July 6, 2009
Ce document est la propiété d'IER et ne doit pas être reproduit ou communiqué sans autorisation écrite.
This document is the property of IER and may not be reproduced or communicated without prior written authorization
