Ier I420, Руководство пользователя

Страница: 26 / 28

i420
User Guide
Page 26
N0L802A1
Ce document est la propriété d'IER et ne doit pas être reproduit ou communiqué sans autorisation écrite.
This document is the property of IER and may not be reproduced or communicated without prior written
authorization
4.3 POOR PRINT QUALITY
1. Make sure that the print parameter settings correspond to the type of
media used, referring to the following procedures:
 Set the media type (see page 17).

Adjust the media thickness (see page 18).
 Adjust the media width (see page 20).
2. Open the printer cover and check the state of cleanliness inside the
printer, especially the printhead and the platen. If necessary request
preventive maintenance execution.
3. If the problem persists, call the help desk.
4.4 FREQUENT ERROR SIGNALS
Message Cause Remedy
COUPON JAM Paper jam Open the cover.
Remove the jammed
paper.
Close the cover.
CUTTER JAM Paper jam at cutter
module
Call the help desk
COVER OPEN The cover is open Close the cover
HEAD UNPLUGGED Print head disconnected Call the help desk
BUSY ATB (or BTP)
Head overheat
Head temperature
above 70 °C
Wait until the
temperature drops
below 60 °C and the
message disappears
HARDWARE
ERROR
Print module error
detected
Call the help desk
OUT OF PAPER
please load bin
Empty paper stock
detected by the ATB
print application
Reload paper
OUT OF PAPER
ERR5O
Empty paper stock
detected by the bag tag
print application
Reload paper