IEMCA KID 80-IV Touch, Руководство по эксплуатации и техническому обслуживанию

Страница: 88 / 92

EN
8 - TROUBLES - CAUSES - CURES KID 80 IV
8 - Pag. 2 / 2
8.1 GENERIC TROUBLESHOOTING
TROUBLES CAUSES SOLUTIONS
The bar feeder will not start Blackout. Check the electrical connection
Open guard. Close the guard.
Emergency devices on. Disconnect the emergency devices.
The bar feeder has been reset
but the automatic cycle will
not start.
No lathe signal. Check the electrical connection
with the lathe.
8.2 BAR MAGAZINE TROUBLESHOOTING
TROUBLES CAUSES SOLUTIONS
During the loading phase, the
bar does not enter the
magazine.
The bar pushing frame is too low. Adjust the bar pushing frame
position (see par. 5.2.).
The first bar in magazine is
not lifted.
The limit stops are not well
adjusted.
Adjust the stops (see par. 5.2.).
The second bar in the
magazine lifts together with
the first one.
The limit stops are not well
adjusted and/or the bar pushing
frame is too high.
Adjust the stops (see par. 5.2.)
and/or the bar pushing frame
position (see par. 5.2.).
8.3 TROUBLESHOOTING DURING BAR FEEDING
TROUBLES CAUSES SOLUTIONS
The bar hardly enters the lathe
spindle.
The guides are not well adjusted. Adjust the guides (see par. 5.3.).
The bar feeder - lathe guide is not
well adjusted.
Adjust the guide (see par. 5.4.).
The bar feeder is not aligned with
the lathe.
Check and correct the alignment.
The bar hardly enters the lathe
collet.
Excessive burr at the bar end. Trim rag before feeding.