IEMCA KID 80-IV Touch, Руководство по эксплуатации и техническому обслуживанию

Страница: 58 / 92

EN
5 - ADJUSTMENTS AND SETTING-UP KID 80 IV
5 - Pag. 4 / 6
5.3 LOADING AXIS ADJUSTMENT
Carry out guide channel height adjustment according to the section of the bars to be machined.
Please carry out guide channel height adjustment following these instructions.
[kid_simb1] Round bars: set the bar diameter measurement on the millimetre-counter.
[kid_simb2] Hexagonal bars: set the measurement of the wrench on the millimetre-counter.
[kid_simb3] Square bars: set the measurement (X) obtained from the following table on the
millimetre-counter:
L = mm X
5 5
8 8
10 10
12 12
15 15
18 18
20 20
22 22
25÷55 40
The adjustment has to be carried out according to the diameter of the bar to be machined.
For the adjustment proceed as follows:
- Rotate the knob (A) until displaying the diameter
of the bar to be machined, on the millimetre
counter (B).
- Check that with the lifted guide (C), the bar is
aligned with the loading axis.
INFORMATION:
Setting bar diameters lower than ø10
(between ø10 and ø5) the guides do not move any further upwards: the bar may
hence not be centred with the spindle axis and could cause vibrations.