IEMCA KID 70, Руководство по эксплуатации и техническому обслуживанию

Страница: 78 / 85

GB
8 - TROUBLES - CAUSES - CURES KID 70
8 - Pag. 2 / 2
8.1 GENERIC TROUBLESHOOTING
TROUBLES CAUSES RIMEDIES
Blackout. Check the electrical connection.
Open carter. Close the carter.
The bar feeder does not start.
Emergencies on. Disable emergencies.
The bar feeder is in start
conditions but the automatic
cycle does not start.
No lathe signal. Check the electrical connection
with the lathe.
8.2 BAR MAGAZINE TROUBLESHOOTING
TROUBLES CAUSES RIMEDIES
During the loading phase, the
bar does not enter the
magazine
The bar pushing frame is too low. Adjust the bar pushing frame
position (see section 5.2.).
The first bar in magazine is not
lifted.
The limit stops are not well
adjusted.
Adjust the stops (see section 5.2.).
The second bar in magazine
lifts together with the first
one.
The limit stops are not well
adjusted and/or the bar pushing
frame is too high.
Adjust the stops (see section 5.2.)
and/or the bar pushing frame
position (see section 5.2.).
8.3 TROUBLESHOOTING DURING BAR FEEDING
TROUBLES CAUSES RIMEDIES
The guides are not well adjusted. Adjust the guides (see section
5.3.).
The bar feeder - lathe guide is not
well adjusted.
Adjust the guide (see section 5.4.).
The bar hardly enters lathe
spindle.
The bar feeder is not aligned with
the lathe.
Check and correct the alignment.
The hardly enters the lathe
collect.
Excessive burr at the bar end. Before loading, remove any burrs
from bars.