![background image](http://html.mh-extra.com/html/iemca/boss-332/boss-332_manual-for-use-and-maintenance_620120070.webp)
4 - HANDLING AND INSTALLATION
BOSS 332/545/552 HD
EN
4 - Pag. 17 / 32
4.5
BAR FEEDER WITH AXIAL DISPLACEMENT DEVICE - INSTALLATION
Before carrying out the installation of the bar feeder, check lathe stability; make sure that it is
firmly fixed to the ground and with a perfectly horizontal spindle axis.
4.5.1 Preliminary
operations
• Roughly position the bar feeder behind the lathe.
• Loosen nuts "A" and screws "B".
4.5.2 Height - Adjustment
The bar feeder is normally supplied with the
working axis height adjusted to the lathe height.
However, if an adjustment is needed, proceed as
follows:
• Refer to “Working axis height” table, in the
"Technical data" section (Ch. 6) for the correct
holes for each screw.
• tighten the lifting chains and remove the 16
screws "A".
• lift the bar feeder according to the required
value "X".
• tighten the "A" screws and remove the "B"
eyebolts.
Содержание BOSS 332
