IEI Technology TANK-801-BT, Руководство пользователя

Страница: 48 / 112

TANK-801 Em b e d d e d S ys te m
P a g e 36
Figure 3-26: USB Device Connection
S te p 3: Insert the device connector. Once aligned, gently insert the USB device
connector into the on-board connector.
Pin Description Pin Description
1 VCC 5 VCC
2 DATA- 6 DATA-
3 DATA+ 7 DATA+
4 GROUND 8 GROUND
Table 3-7: USB Port Pinouts
3.8 In te rn a l P e rip h e ra l In te rfa c e Co n n e c to rs
3.8.1 TP M Mo d u le In s ta lla tio n
To install the TPM module, please follow the steps below:
S te p 1: Remove the two retention screws on the rear panel and loosen the two
thumbscrews on the front panel, slide the cover inwards, and then lift the cover
up gently ( Figure 3-4 ).
S te p 2:
Locate the TPM connector. The location of the TPM connector is shown in
Figure 3-27 .