Rev. 02 | English | 5
Installation
1
2
3
4
66 mm
98 mm
66 mm
8,7 mm
91,2 mm
59,2 mm
Combipad
Befestigungsrahmen
Einbaulochung
Prepare the installation hole on the door front
according to the installation dimensions described
below. Note that for wooden and HPL fronts, an
adapted two-stage recess for the mounting frame (see
illustration) needs to be milled. This recess is not
required for metal fronts.
Place the mounting frame into the installation hole on the
inside of the door and hold it in position.
Insert the lock body from the outside of the door, with
the latch leading, into the installation hole. Then, check if
the lock body is fully seated on the outside of the door.
Secure the mounting frame to the lock body using the
four screw holes. Tighten the screws hand-tight (2 Nm)
while ensuring the required screw length is used. The
screw length depends on the thickness of the door in
which the lock is being installed.
Check if the latch securely engages with the strike plate or
the door jamb when in the locked position (approximately
5 mm). The latch should smoothly fall into its final
position without any pressure when the locking system is
closed.
Note: The closing can be adjusted optimally by using an
adjustable strike plate.
Installation dimensions
The dimensions for the installation hole on the outside
of the door apply to installation in wooden, HPL, and
steel fronts..
For wooden and HPL fronts, an additional recess on the
inside of the door is required. The dimensions of
the milling correspond to the dimensions of the
mounting frame.
Note: The drawings shown here are not to scale and are
not suitable as milling templates.
5
66 mm
98 mm
66 mm
8,7 mm
91,2 mm
59,2 mm
Combipad
Befestigungsrahmen
Einbaulochung
66 mm
98 mm
66 mm
8,7 mm
91,2 mm
59,2 mm
Combipad
Befestigungsrahmen
Einbaulochung
ID LOCK 4000 | 07-2023
Содержание ID LOCK 4000
Страница 1: ...ID LOCK 4000 Manual...
